Presented by DOMO Engineering Plastics
Recorded on September 15, 2022
Vibration welding of injection molded polyamide parts is a common practice when it comes to producing complex assemblies in many fields of application. To increase the efficiency of the development process, virtual prototyping using integrative structural MMI simulation is of particular importance. But proper validation of the simulation process is needed to build confidence in the methodology, especially when it comes to parts with important mechanical loads. DOMO Engineered Materials experts have therefore developed a demonstrator to test parts performance under load and with internal pressure of fluids.
In this seminar you will learn how this demonstrator can help you to evaluate vibration welding performance. This is backed up by the full set of DOMO testing capabilities and expertise within the field of highly predictive integrative structural simulations with the MMI Service.
Watch the Webinar Recording
Download the Slides
Contact Wido ZIEMER / Ask a Question
The views, opinions and technical analyses presented here are those of the author or advertiser, and are not necessarily those of ULProspector.com or UL Solutions. The appearance of this content in the UL Prospector Knowledge Center does not constitute an endorsement by UL Solutions or its affiliates.
All content is subject to copyright and may not be reproduced without prior authorization from UL Solutions or the content author.
The content has been made available for informational and educational purposes only. While the editors of this site may verify the accuracy of its content from time to time, we assume no responsibility for errors made by the author, editorial staff or any other contributor.
UL Solutions does not make any representations or warranties with respect to the accuracy, applicability, fitness or completeness of the content. UL Solutions does not warrant the performance, effectiveness or applicability of sites listed or linked to in any content.