Recorded Thursday, May 5 at 11AM EDT – Presented by EPS
Is maintaining a balance of properties between corrosion, hardness and block an ongoing challenge?
Is working within a narrow formulation latitude causing you to use multiple resins and expensive additives for your product line?
Is formulating to meet VOC restrictions limiting your product performance?
EPS® Next Generation <100 g/L DTM emulsion bridges the gap between these issues, improving your product development cycle.
Learn more about this versatile resin by view our webinar presented by Dr. Allen Bulick of EPS Materials.
The views, opinions and technical analyses presented here are those of the author or advertiser, and are not necessarily those of ULProspector.com or UL. The appearance of this content in the UL Prospector Knowledge Center does not constitute an endorsement by UL or its affiliates.
All content is subject to copyright and may not be reproduced without prior authorization from UL or the content author.
The content has been made available for informational and educational purposes only. While the editors of this site may verify the accuracy of its content from time to time, we assume no responsibility for errors made by the author, editorial staff or any other contributor.
UL does not make any representations or warranties with respect to the accuracy, applicability, fitness or completeness of the content. UL does not warrant the performance, effectiveness or applicability of sites listed or linked to in any content.