Recorded May 6, 2009
Presented by John Daniels & Martin Baumann, Husky Injection Molding Systems
Lower cycle times, fewer defects and higher productivity are just a few of the benefits of a hot-runner system. However, many times these benefits aren’t realized because hot-runner designers weren’t involved in the early stages of design.
This recorded webinar will show how critical design decisions such as gate geometry and location need to be considered when designing plastic parts. It also explores the use of simulation tools such as MoldFlow, CFD, and FEA can improve part design and productivity.
The views, opinions and technical analyses presented here are those of the author or advertiser, and are not necessarily those of ULProspector.com or UL Solutions. The appearance of this content in the UL Prospector Knowledge Center does not constitute an endorsement by UL Solutions or its affiliates.
All content is subject to copyright and may not be reproduced without prior authorization from UL Solutions or the content author.
The content has been made available for informational and educational purposes only. While the editors of this site may verify the accuracy of its content from time to time, we assume no responsibility for errors made by the author, editorial staff or any other contributor.
UL Solutions does not make any representations or warranties with respect to the accuracy, applicability, fitness or completeness of the content. UL Solutions does not warrant the performance, effectiveness or applicability of sites listed or linked to in any content.
Leave a Reply or Comment