Recorded April 14th, 2013
Presented by Proto Labs
In this 20 minute webinar, Tony Holtz lays out basic design “rules” for successful plastic injection molding. As with many of life’s rules, some of these can be bent if absolutely necessary. But bending rules has costs and consequences, and this webinar addresses ways to work with the process and within its guidelines to make the most of injection molding’s flexibility and enormous potential. The webinar touches on issues of Design, Tools, Material Selection, and Moldability.
Download the slides
Answer these questions to download the slides.
The views, opinions and technical analyses presented here are those of the author or advertiser, and are not necessarily those of ULProspector.com or UL. The appearance of this content in the UL Prospector Knowledge Center does not constitute an endorsement by UL or its affiliates.
All content is subject to copyright and may not be reproduced without prior authorization from UL or the content author.
The content has been made available for informational and educational purposes only. While the editors of this site may verify the accuracy of its content from time to time, we assume no responsibility for errors made by the author, editorial staff or any other contributor.
UL does not make any representations or warranties with respect to the accuracy, applicability, fitness or completeness of the content. UL does not warrant the performance, effectiveness or applicability of sites listed or linked to in any content.
Leave a Reply or Comment