Recorded April 25, 2013
Presented by Husky Injection Molding Systems
In today’s highly competitive production environment molders need to produce the highest quality parts in the most efficient way possible. Producing parts with cold runners is an inefficient and expensive process – cycle times are extended and scrap is produced with every cycle that directly affects your bottom line.
This webinar discusses why direct side-gating parts with a hot runner is the easiest way reduce part cost, while achieving the required gate quality and part tolerances for precision components such as medical and technical parts. Ed also examines how variability and risk can be minimized with side-gating technologies.
Download the slides
Answer these questions to download the slides.
The views, opinions and technical analyses presented here are those of the author or advertiser, and are not necessarily those of ULProspector.com or UL. The appearance of this content in the UL Prospector Knowledge Center does not constitute an endorsement by UL or its affiliates.
All content is subject to copyright and may not be reproduced without prior authorization from UL or the content author.
The content has been made available for informational and educational purposes only. While the editors of this site may verify the accuracy of its content from time to time, we assume no responsibility for errors made by the author, editorial staff or any other contributor.
UL does not make any representations or warranties with respect to the accuracy, applicability, fitness or completeness of the content. UL does not warrant the performance, effectiveness or applicability of sites listed or linked to in any content.
Leave a Reply or Comment