Recorded July 19th, 2010
Presented by Husky
Resin costs and overall productivity are key drivers for a molders profitability. Especially in small part molding the use of cold runners is still common but a more expensive way to mold parts. New technologies in hot runners continue to push the envelope on how small a part can be direct-gated. In the past few years there have been significant improvements in hot runner capabilities to direct-gate small parts.
Our webinar “Increase productivity and save resin by direct-gating small parts” will discuss some of the resin specific challenges of molding small parts and also demonstrate some of the latest technological advancements and innovations in hot runners and how they can help you direct-gate smaller parts than ever before. At the end of this webinar you will have a better understanding of the challenges and opportunities of small part molding via direct-gating the part and how you can capitalize on these advancements.
Answer these questions to download the slides.
The views, opinions and technical analyses presented here are those of the author or advertiser, and are not necessarily those of ULProspector.com or UL Solutions. The appearance of this content in the UL Prospector Knowledge Center does not constitute an endorsement by UL Solutions or its affiliates.
All content is subject to copyright and may not be reproduced without prior authorization from UL Solutions or the content author.
The content has been made available for informational and educational purposes only. While the editors of this site may verify the accuracy of its content from time to time, we assume no responsibility for errors made by the author, editorial staff or any other contributor.
UL Solutions does not make any representations or warranties with respect to the accuracy, applicability, fitness or completeness of the content. UL Solutions does not warrant the performance, effectiveness or applicability of sites listed or linked to in any content.
Leave a Reply or Comment